 |
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
| Datasheet File OCR Text: |
| Product Specification PC Power Supply Supervisors SG6510X1 via VDD pin); under voltage sense (UVS) monitoring for 3.3V and 5V; and under voltage protection (UVP) monitoring for 3.3V and 5V. When 3.3V or 5V voltage is decreasing to 2.8V and 4.2V respectively, the under voltage sense (UVS) function will be enabled to reset the PGO signal from high to low. If 3.3V or 5V voltage is further decreasing to 2.5V and 3.6V respectively, FPO will be set to high to turn off the PWM controller IC. To achieve better immunity for lighting surge glitch and to prevent accidental power shut down during dynamic loading condition, the de-bounce time for UVP and UVS is 2mS/1mS respectively. The deglitch time for OVP is 75uS for better noise immunity. During AC sag or brownout situation, the UVP functions still can be enabled to protect power supply in case of output short circuit. The power supply is turned on after 38mS de-bounce time when PSON signal is set from high to low. To turn off power supply, PSON signal is set from low to high and the de-bounce time is 38mS. The PGI circuitry provides a sufficient power-down warning signal for PGO. When PGI input is lower than the internal 1.2V reference voltage, after 350uS de-bounce time, the PGO signal is pulled low. FEATURES Over-voltage protection (OVP) for 3.3V, 5V and 12V Under-voltage sense (UVS) and protection (UVP) for 3.3V, 5V Open drain output for PGO and FPO pins 300mS power good delay 75mS turn on delay for 3.3V and 5V 2.8mS PSON control to FPO turn-off delay 38mS /38mS PSON control De-bounce 350uS width noise deglitches 2mS UVP De-bounce time 1mS UVS De-bounce time No lockup during the fast AC power on/off Brownout protection function for 3.3V and 5V Wide supply voltage range from 4V to 15V DESCRIPTION SG6510 is designed to provide the voltage supervisor function, remote on/off PSON function, power good (PGO) indicator function, and fault protection (FPO) function for switching power systems. For supervisor function, it provides the over voltage protection (OVP) monitoring for 3.3V, 5V and 12V (12V TYPICAL APPLICATION 5V 5V SG6510 PGI 1 2 3 PSON 4 PGI GND FPO PSON PGO VDD VS5 VS33 8 7 6 5 5V 3.3V 12V 5VSB (c) System General Corp. Version 1.0 ( IRO33.0025.B0) -1- www.sg.com.tw Feb.27,2004 Product Specification PC POWER SUPPLY SUPERVISORS SG6510X1 PIN CONFIGURATION MARKING INFORMATION 8 T: D = DIP PGI GND FPO PSON 1 2 3 4 8 7 6 5 PGO VDD VS5 VS33 SG6510T1 XXXXXXXYYWWV XXXXXXX: Wafer Lot YY: Year; WW: Week V: Assembly Location 1 ORDERING INFORMATION Part Number SG6510D1 Package Type 8 pins DIP Plastic PIN DESCRIPTIONS Pin No. Pin Name Type 1 2 3 PGI GND FPO Analog input Supply Logic output Description Power good input. For ATX SMPS, it detects main AC voltage under-voltage and/or failure. Ground. Fault protection output (invert). Output signal to control the PWM IC. For example it controls the PWM IC of primary side through an opto-coupler. When FPO is low, the main SMPS is operational. Remote On/Off logic input from CPU or main-board. Turn on/off the PWM output after 38mS / 38mS delay. 3.3 V over/under-voltage control sense input. 5 V over/under-voltage control sense input. Supply voltage. 4V ~ 15V. For ATX SMPS, it is connected to 5V-standby and 12V through diodes respectively. Power good logic output, 0 or 1(open-drain). Power good=1 means that the power is good for operation. The power good delay is 300mS. 4 5 6 7 8 PSON VS33 VS5 VDD PGO Logic input Analog input Analog input Supply Logic output (c) System General Corp. Version 1.0 ( IRO33.0025.B0) -2- www.sg.com.tw Feb.27,2004 Product Specification PC POWER SUPPLY SUPERVISORS SG6510X1 FUNCTION TABLE PGI PGI<1.2V PGI<1.2V PGI<1.2V PGI<1.2V PGI<1.2V PGI<1.2V PGI<1.2V PGI<1.2V PGI>1.2V PGI>1.2V PGI>1.2V PGI>1.2V PGI>1.2V PGI>1.2V PGI>1.2V PGI>1.2V X PSON L L L L L L L L L L L L L L L L H UV Sense (3.3V or 5V) No Yes No No Yes Yes No Yes No Yes No No Yes Yes No Yes X UV Protection (3.3V or 5V) No No Yes No Yes No Yes Yes No No Yes No Yes No Yes Yes X OV Protection No No No Yes No Yes Yes Yes No No No Yes No Yes Yes Yes X FPO L L L H L H H H L L H H H H H H H PGO L L L L L L L L H L L L L L L L L x = don't care FPO = L means: fault IS NOT latched FPO = H means: fault IS latched PGO = L means: fault PGO = H means: No fault (c) System General Corp. Version 1.0 ( IRO33.0025.B0) -3- www.sg.com.tw Feb.27,2004 Product Specification PC POWER SUPPLY SUPERVISORS SG6510X1 BLOCK DIAGRAM (c) System General Corp. Version 1.0 ( IRO33.0025.B0) -4- www.sg.com.tw Feb.27,2004 Product Specification PC POWER SUPPLY SUPERVISORS SG6510X1 TIMING DIAGRAM (c) System General Corp. Version 1.0 ( IRO33.0025.B0) -5- www.sg.com.tw Feb.27,2004 Product Specification PC POWER SUPPLY SUPERVISORS SG6510X1 ABSOLUTE MAXIMUM RATINGS Symbol VDD Vi VOUT TA TSTG Parameter DC Supply Voltage Input Voltage Output Voltage Operating Free Air Temperature Range Storage Temperature Range Soldering Temperature ESD Capability, HBM model FPO PGO Min. -0.3 PSON, VS33, VS5, PGI -0.3 -0.3 -0.3 -40 -55 Max. 16 8 16 8 85 150 260 2 Unit V V V KV Note: Stresses above those listed may cause permanent damage to the device. RECOMMENDED OPERATING CONDITIONS Symbol VDD VIL VOUT IoSINK TR TA Parameter DC Supply Voltage Input Voltage Output Voltage Output Sink Current Supply Voltage Rising Time Operating Free Air Temperature Range PSON, VS33, VS5, PGI FPO PGO FPO PGO See Note Min. 4 Max. 15 7 15 7 20 10 Unit V V V mA mS 1 -30 85 Note: VDD rising and falling slew rate must be less than 14V/mS. ELECTRICAL CHARACTERISTICS (VDD=12V, TA=25) Over-voltage Protection Symbol VOVP ILKG VOL TOVP Parameter Over-voltage Protection VS33 Over-voltage Protection VS5 Over-voltage Protection VDD Leakage Current (FPO) Low Level Output Voltage (FPO) Timing OVP to Protection Test Conditions Min. 3.7 5.7 13.2 Typ. 3.9 6.1 13.8 Max. 4.1 6.5 14.4 5 0.7 Unit V uA V uS V(FPO) = 5V Isink 20mA 33 75 110 (c) System General Corp. Version 1.0 ( IRO33.0025.B0) -6- www.sg.com.tw Feb.27,2004 Product Specification PC POWER SUPPLY SUPERVISORS SG6510X1 Under-voltage and PGI, PGO Symbol VPGI VUVS VUVP TUVS TUVP ILKG VOL Parameter Input Threshold Voltage PGI Under-voltage Sense VS33 Under-voltage Sense VS5 Under-voltage Protection VS33 Under-voltage Protection VS5 Timing UVS to Sense (PG) Timing UVP to Protection (FPO) Leakage Current (PGO) Low Level Output Voltage (PGO) Under-voltage Enable Delay Time Test Conditions Min. 1.15 2.6 4.0 2.3 3.4 0.6 1.3 Typ. 1.2 2.8 4.2 2.5 3.6 1 2 Max. 1.25 3.0 4.4 2.7 3.8 1.5 3 5 0.7 Unit V V V mS mS uA V mS mS uS PGO = 5V VDD = 12V Isink 10mA 49 200 200 75 300 350 114 450 450 TPG Timing PG Delay Noise Deglitch Time PGI to PGO PGI to PGO PSON Control Symbol IPSON VIH VIL TPSON TPSOFF Parameter Input Pull-up Current High-level Input Voltage Low-level Input Voltage Timing PSON to On/Off On Off Timing PG Low to Power Off Test Conditions PSON = 0V Min. 100 2.4 Typ. 160 1.85 1.35 Max. 220 1.2 57 57 4.5 Unit uA V V mS mS 24 24 1.6 38 38 2.8 Total Device Symbol IDD Parameter Supply Current Test Conditions PSON = 5V /VDD = 5V Min. Typ. 0.7 Max. 1.5 Unit mA (c) System General Corp. Version 1.0 ( IRO33.0025.B0) -7- www.sg.com.tw Feb.27,2004 Product Specification PC POWER SUPPLY SUPERVISORS SG6510X1 PACKAGE INFORMATION 8 PINS - PLASTIC DIP (D) D 8 5 E1 E eB 1 4 A1 A2 L b1 b e Dimension Symbol A A1 A2 b b1 D E E1 e L eB Millimeter Typ. Inch Typ. Min. 0.381 3.175 A Max. 5.334 3.429 Min. 0.015 0.125 Max. 0.210 0.135 9.017 6.223 2.921 8.509 0 3.302 1.524 0.457 9.271 7.620 6.350 2.540 3.302 9.017 7 10.160 6.477 3.810 9.525 15 0.355 0.245 0.115 0.335 0 0.130 0.060 0.018 0.365 0.300 0.250 0.100 0.130 0.355 7 0.400 0.255 0.150 0.375 15 (c) System General Corp. Version 1.0 ( IRO33.0025.B0) -8- www.sg.com.tw Feb.27,2004 Product Specification PC POWER SUPPLY SUPERVISORS SG6510X1 8 PINS - PLASTIC SMD (S) 8 5 C 1 b 4 e D A1 A Dimension Symbol A A1 b c D E e F H L Millimeter Typ. Inch Typ. Min. 1.346 0.101 0.406 0.203 4.648 0.381 1.270 0.381X45 5.791 0.406 0 6.197 1.270 8 0.228 0.016 0 4.978 3.987 0.183 0.150 (c) System General Corp. Version 1.0 ( IRO33.0025.B0) H F E L Max. 1.752 0.254 Min. 0.053 0.004 Max. 0.069 0.010 0.016 0.008 0.196 0.157 0.050 0.015X45 0.244 0.050 8 -9- www.sg.com.tw Feb.27,2004 Product Specification PC POWER SUPPLY SUPERVISORS SG6510X1 DISCLAIMERS LIFE SUPPORT System General's products are not designed to be used as components in devices intended to support or sustain human life. Use of System General's products in components intended for surgical implant into the body, or other applications in which failure of the System General's products could create a situation where personal death or injury may occur, is not authorized without the express written approval of System General's Chief Executive Officer. System General will not be held liable for any damages or claims resulting from the use of its products in medical applications. MILITARY System General's products are not designed for use in military applications. Use of System General's products in military applications is not authorized without the express written approval of System General's Chief Executive Officer. System General will not be held liable for any damages or claims resulting from the use of its products in military applications. RIGHT TO MAKE CHANGES System General reserves the right to change this document and/or this product without notice. Customers are advised to consult their System General sales representative before ordering. (c) System General Corp. Version 1.0 ( IRO33.0025.B0) - 10 - www.sg.com.tw Feb.27,2004 |
Price & Availability of SG6510D1
 |
|
|
|
|
All Rights Reserved © IC-ON-LINE 2003 - 2022 |
| [Add Bookmark] [Contact Us] [Link exchange] [Privacy policy] |
|
Mirror Sites : [www.datasheet.hk]
[www.maxim4u.com] [www.ic-on-line.cn]
[www.ic-on-line.com] [www.ic-on-line.net]
[www.alldatasheet.com.cn]
[www.gdcy.com]
[www.gdcy.net] |